I plan too. I can't get windows to load at 51 multiplier. Just keeps crashing even at 1.54VCore.

Valley keeps crashing.

This post was edited by NinjaSushi2 on Nov 28 2013 02:57am

My 3930K is finally degrading after a long time at high clocks and voltages. It can no longer bench at 5GHz, was thinking about sending it in for a replacement since I bought the Intel replacement plan, however I seem to have a good IMC since memory runs tight timings at 1200MHz.

I've not used IB yet so I don't know much about those chips.

This post was edited by Halfdead14 on Nov 28 2013 03:25am

My 2550K was not this hard to stable.

This post was edited by NinjaSushi2 on Nov 28 2013 03:39am

5GHz. http://valid.canardpc.com/jc626u



Now at 1.59-1.596 VCore.

This post was edited by NinjaSushi2 on Nov 28 2013 04:05am

Fuck this. This damn chip can't hit 5GHz stable no matter what I try. POS just crashes left and right even at 1.6V with C states turned off and PLL at 1.9V. Ideas? I even reduced my memory to 1333.

1.6V?

You trying to brick it?

Hopefully. I changed some settings at hit 5GHz @ 1.5V.



Can't get Unigine Valley to load. Can't tell if it's shitty bootlegged windows or funky OC.

This post was edited by NinjaSushi2 on Nov 28 2013 04:52am

Dang. I tried to OC the crap out of my system to pump out massive WU on F@H and I am getting BSOD now. haha Better up that VTT.

Pretty sure overclocking has a negative affect on F@H.
I was getting better WU 17 results under stock clocks rather than my 24/7 overclocks.

Hmm.. did not know that. Never done it so. Maybe I can find a more stable OC and try valley again but with higher mem clocks.