Should be 2600MHz, since your ram runs at 5200 MTs. So an extra 1600MHz. If you can’t get past 997MHz you might have a bad ram stick or a motherboard issue going on
I did some testing with the standard profilies, before manually changing the parameters in the BIOS.
Result: with the original two factory RAM's installed I managed to get up to 5200 MT/s (XMP 1 Profile). When having 4x RAM's installed (by adding the new bought RAM's) I only manage to get to 2000 MT/s with the two XMP Profiles in the BIOS.
The next step would be to manually set the BIOS parameters,
but I am kinda afraid of it. Do you have any suggestions? I mean I think I would have to change all parameters manually probably
RAM Slots:
#1/#3: KF552C40BBAK2-32 (
"new bought RAM's" - Label says 1.25V which according to datasheets indicates XMP Profile #1 5200)
#2/#4: HP52U40S8HM-16FRAE (
"factory RAM's" - Label it says: 16GB 1Rx8 XMP5 - 5200 - UAO - 1010 -XT)
Standard profiles which can be selected in BIOS:
- Default
- Custom
- XMP1 5200 (screenshot below)
- XMP2 4800 (screenshot below)


This post was edited by SIVIART on Mar 16 2025 08:49am