Hello.

I finally asembled my new pc but the damn thing keeps saying “ No Signal “ on monitor.

Lian li 011 mini the beauty one
I5-13600k
3060Ti
2x 16 GB rams
Coolermaster V Series 750 Gold SFX.
7 led fans

Fans and led and rams running.

Ive tried this so far:

Unplugging GPU and put it in again.
Unplug all cables from PSU and put in again.
Take the little battery in motherboard out and hold off Button 10 seconds.
Took each ram out at a time to test, nothing worked.
Removed cpu and check if everything was okay.

Really did the most but wont work. I have to mention my monitors work perfectly with my current pc.

The pc just turns on and saying no signal…

Help me please 😣

might be the PSU (don't think it is), or the mobo is failing to post. what's the model for the motherboard? check reviews to see if others have any issues

Is there a place to plug the monitor directly into the motherboard? start there first. after you're done with the setup then use the GPU. Also make sure your CPU power is plugged in and properly seated.

Ive checked mostly everything, done everything..

Tried to plug in motherboard dont work. Then GPU dont work either.

The USB panels works fine…

Take it to Best Buy or somewhere near you. They can identify for you pretty cheap. To make sure no faulty equipment

I wonder if your monitor settings are correct? Set to HDMI if using HDMI? DP if using DP?

Is this your first build you've done yourself?

I don't want to sound condescending but sometimes It's something simple so I always start there.
Are you 100% positive the cord for the motherboard is seated properly, all pins are in good shape and the connector itself does not have any loose plugs in it that might not be making a full or proper connection?
Are you sure the 8 pin is completely seated and undamaged for the CPU power? Is this plugged in at all?(I ask because I've seen it)
Also make sure that all of your stand offs for the motherboard and installed correctly and the board itself is secured properly.
Is the RAM in the recommended slots/configuration per your manual? It's possible for one set to perhaps have a problem from manufacture.
I'm assuming your power supply is Modular meaning you can unplug directly from the PSU itself based on what you've mentioned. Have you tried plugging the previously mentioned CPU power cable into a different port that will support 8 pin CPU? Could be a dead one in the PSU

The USB you mentioned, is it the USB's on the motherboard itself or the ones on your case?

Your motherboard needs an update. You need to buy a Z790. Thank me later bro :-)

this, check compatibility with processor because it might need an bios update and if it's so, you need to send it back for it or buy a low cost compatible processor to perform it.

This post was edited by Icewind on Jan 15 2023 06:14am

Worked like a charm! Thank u bruuuuv