ok with cS3, when i had cs2, id hit the move tool, and just drag my render onto my sig, but with cs3 when i do that, it makes the image very very small, and i have resize, is it always like that or are my setting fucked up

my brushes also seem to small, even when i use that bar thing to increase the size, their still to small

with cs2 i use to be able to make them bigger then my sig, but now it seems that they don't even go full sig size ( making it hard to do backgrounds )

also when i make a new sig when i put the size at say

350, 110

it seems fucking huge, so i have to zoom out lots, is it like this for everyone?

i wish i could find a trustable CS2 torrent ><

You need to make sure your resolution is set at 72 pixels per inch when making the file.
Thats probably the problem you're having.

EXAMPLE:

what about my brushes?

click on the brush in the top left, and move the bar (master diameter) to as high as you want it. or just click in the box that says like # px. and input the number you want it to be. it goes up to 2500 pixels, so you should be fine there.

thats what im doing, but look



all my brushes are like that...are yours? do i just need better brushes for bigger sizelike wtf, i need much much bigger brushes

You're only zoomed in too 2%, you need to set your zoom at 100% or your document/work area is going to look tiny!
Thats your whole problem xD
Look in the bottom left corner and you'll see a 2% change that to 100% to see the real size =]

I found your real problem.
You're making your document 350inces by 110inches, you need to make it 350 pixels by 110 pixels.

Refer to the image posted in my previous post, it says 1440 pixels not inches by 900 pixels not inches.

This post was edited by swordhunter4ever on Apr 12 2008 11:47pm