Someone can explain me why parts picker say the cooler master hyper 212 is incompatible with my mid tower , thermaltake versa II ? That maybe a dimension probleme but that strange because its not a small tower its like normal size and that suposed to fit .

http://pcpartpicker.com/p/8p8wLk

http://www.thermaltakeusa.com/products-model.aspx?id=C_00001998

This post was edited by mik979 on Dec 15 2015 09:49pm

cos the official website says limit is 155mm,
http://www.thermaltakeusa.com/products-model_Specification.aspx?id=C_00001912

and 212 is 159mm

but im sure it'll fit. pcpartpicker just goes by official measurements given

This post was edited by Secksii on Dec 15 2015 09:53pm

Oh ok so im better to try it by myself before , and do you that gona help to get space if i dont put rear top fan or that dosnt matter ?

wont matter

Ok i just checked because i dont have my mother board yet but i placed my cooler inside my tower and i think that gona fit but verry tight. maybe the end of the pipes gona touch my side panel .

the side panel sticks out a bit too

only way for you to find out is to play around with the case when u get ur mobo, if the CPU slot on mobo is placed nicely it should fit. Otherwise you may have to keep side panel off, or top fan off, etc.

shoulda went with another cases to save the trouble

Ok ill check that ... Thx for your help man

If it touches, youre gonna have an extended heat leader

If Thermaltake says it won't fit, then it won't fit.

/e I would think that Thermaltake KNOWS the sides of the case stick out a bit.

This post was edited by Ghot on Dec 16 2015 04:00am

Maybe ill just put the normal cooler included in my processor box and ill put like 4 fans in my tower , like botom and front one for intake and my rear and top one for exaust , that not suposed to heat with a good aeration and the normal cooler , the only thing that gona do is make more noise because de fan included in my processor box is smaller

This post was edited by mik979 on Dec 16 2015 07:28pm