so i built my pc last night.
everythings connected properly , in the right place anyways.

my heatsink powers on, my channel fans, the mobo lights up.
but i have absolutely NO peripheral power, no usb 2.0's or 3.0's or VGA connection for my monitor.. no signal leaving the pc at all.

i reseated ram, plugged/unplugged in my cpu 8 pin and my 20+4 pin connectors.

nothing works.

i think its a bad mobo (kingarthur helped me)
im just wondering if anyone else has had similar issues.

everything was brand new
fortunately i can replace my mobo at the store this weekend for free, should i replace my ram too?

he knows more than most

http://dlcdnet.asus.com/pub/ASUS/mb/SocketAM4/PRIME_B350-PLUS/PRIME_B350-PLUS_Memory_QVL_20170406.PDF?_ga=1.250681092.329596230.1492013058

i think thats supported ram

http://www.memoryexpress.com/Products/MX58471

thats my ram

i dont see the same model number.
could that be it?

would that stop my peripherals from working?

The USB ports you're referring to, they are on motherboard or on tower?

The VGA output is on board graphics? No external GPU?

Have you tried resetting CMOS?

Also, post full build

This post was edited by HyphyIll on Apr 26 2017 08:39am

both (for usb's)
vga is on board, i dont have a dvi-d cable for my GPU yet so thats why its on board to my mobo.

not sure how to reset cmos



full build

asus b350 plus
ryzen 5 1600
corsair vengeance (2133mhz) 2x 4g sticks
evga 1050 gtx ti
evga 500w psu
OCZ 256gb ssd

This post was edited by Tear on Apr 26 2017 08:45am

The circular battery on the mobo, pull it out for 15 sec and put back in.

ill try this when i get home.

looking @ this list

http://dlcdnet.asus.com/pub/ASUS/mb/SocketAM4/PRIME_B350-PLUS/PRIME_B350-PLUS_Devices_report.pdf?_ga=1.19549370.329596230.1492013058

my PSU isn't on the list
but it powers up obviously, is there a reason for that?

That PSU will be fine.

But if cmos resetting doesn't work then yea exchange mobo.

do you think it has anything to do with ram?
cause its not on supported list?

and for the battery.
it just clips in right
i just snap it out and push it back in?


e/

obvious all power off when i do that right

This post was edited by Tear on Apr 26 2017 08:52am

Resetting the CMOS forces factory settings and in some cases I've seen mobos with x ram not boot up because it doesn't support the speeds. After a cmos reset it defaults to a setting it will support.

However, I don't know much about ryzen and what it does and doesn't support.

And yes on the battery