Fresh build. Had trouble at setup getting a signal. Resat the ram and gpu. And it was fine. Installed windows from a USB, no problems.
Today I went to get drivers set up, had to put the LAN drivers for the mother board on USB, got them installed. Once connected, I went online downloaded google chrome, installed and then lost my signal to the monitor.
I can boot the bios and get a display signal but once I try and load the comp it says no signal.
Any advice?

Sounds like you got bad drivers
Boot into safe mode
Redo graphic drivers

I got it going. Not sure what the problem was.
But after doing all the drivers it seems under control

shaft just told you the issue, how do you not know what it was?

I hadn't even done the graphics drivers when I had the issue.
As I stated, I installed windows and the LAN drivers.

windows installs drivers automatically in background.