Remove that fucking tag from that wire on the cpu fan. good grief man have some self respect.
All the wires going into your mobo (for case and such) on bottom should be able to come out where the sata cables are for ssd and plug into mobo there.

Other than those few things...you did....excellent.

Even more so, because it works as well.

Will do. Other than that, not too shabby?.

My hdd isn't showing up, only my ssd. Is that something I can change in bios? It's showing up in disk management. But I can't initialize it or give it a lettered drive.

This post was edited by FzFroGG on Aug 5 2016 04:08pm

If it shows up in the BIOS, then you know it's hooked up properly. Also, make sure that w/e SATA port you used for the HDD, is "Enabled" in the BIOS.

This post was edited by Ghot on Aug 5 2016 04:13pm

screen shot disk management.

Could also just be that it isn't formatted.

As a user with the same case, if you care about aesthetics you can bend your cables and place them under the cable entrance rather than going over it.

Also is there a reason for that 4pin cable to be crossed over everything? Is it not long enough?

Also when I installed my GPU I brought the power cables directly down into the hole where the 4 pin power is coming from.

Over all it could be cleaned up a lot. The case has more potential than that.

Also be aware you have zero air intake fans, only exhaust. I recommend bringing the top exhaust fan to the front of the case in line with your 212.



This post was edited by AbDuCt on Aug 5 2016 04:19pm

Are you right clicking the big partition on that HDD or where it says Disk 1?

Yeah another person said to do that with the GPU cables, I just wanted to get everything running first. I'll probably go back and fix that. Yours looks really clean, I just need a bit more time to work on aesthetics.