I did this at work today:

Stealing someones power?

...



<superkuh> https://www.crowdsupply.com/lime-micro/limesdr - 2x2 MIMO Gnu Radio supporting SDR board with USB3 limited bandwidth going for $199 right now.
<superkuh> About $50 less than the per 100 unit BOM parts cost for one board.
<superkuh> So the final, not crowd funded version will be significantly more expensive

Buy me it I'm poor :<

So your saying we should touch the screw right?

http://i.imgur.com/lrhooE5.gifv

Do we have any metal fabricators here?

Was wondering if I could get some parts machined for the cheap cheap.

If not I'll do it myself on my mini milling machine, but a cnc machine would be nicer.

This post was edited by AbDuCt on May 3 2016 06:41pm

I cut 10ga 7ga and qtr inch sheets our milling machine is out of commission

Oh and 14ga

Mostly steel but lmk

This post was edited by yupitsmeh on May 3 2016 07:07pm

I need some 0.040 (ish, I can't recall sizing) aluminum plates cut. They need to be pretty precise so I need to find someone with a CNC milling machine or laser cutter or something.

I'm in need of making a tuning capacitor.

http://fucimin.altervista.org/loop/design_butterfly.gif

The two pieces to the right are about what I need. like 10-20 of the butterfly shape and 20-40 of the triangle shape.

I'll have to finalize my sizes since I need to change them to include a hex center hole for the stater and figure out what size ready rod I want to use for the frame.

This post was edited by AbDuCt on May 3 2016 07:14pm