gonna be sexi build ^^

how do i know whats positive and negative for the front pannel leds

on my psu the 24pin is broken up into like 20+4 for mobo and like 16+8 for the psu input, i see where i connect the 16 but can i just connect the 8 into any open slot?

for the 8pin eps do i do the same, just connect it to any open 8 pin slot?

don't understand the question....understand the words...just not what you mean...I would read the PSU book

for case front panel leads...white = negative

This post was edited by ghot on Oct 1 2011 03:14pm

both the wires are black

well the book doesnt say anything about it i just says conect the 24 to the mobo and to the psu

I have the same PSU aren't the cables rigid.
Other than the fact the cables are rigid though the psu is a beast.

yeah they seem a bit rigid, esp near my grommet :[

Are you using a stock heatsink?
You might have to end up taking that mobo out if not lol.

theres a cut out, im using the rasa 240 water cooling

i wonder if ican can fit a rad + 2 layers fans...

i think i can only use one last of fans :[

This post was edited by Hermione on Oct 1 2011 04:26pm

omg you spent 70bux 2 much on psu
a blue hdd
and that damn asrock