So I have both Monitors hooked up and I can duplicate the screen so I know theyre both hooked up, but when I go to:
-> Multiple Displays - Extend these Settings I cannot drag anything to the old (#2) monitor.

What am I doing wrong? Please help! I've googled it and watched Videos about set up and I just don't get it.

thanks in Advance!

*I just looked again and I CAN and did "Identify" it and everything appears to be correct, but still no joy moving things over

This post was edited by Randz66 on Oct 21 2017 04:01am

your welcome

Not sure why you'd say that..
..

I still need assistance.

this

When you ID'd the monitors, are Monitor 1 and Monitor 2 aligned in settings the way they are physically on your desk? You need to make sure the settings alignment is correct, as that dictates where the border between the two screens is (drag to the left vs drag to the right).

This post was edited by Surfpunk on Oct 21 2017 01:12pm

LOL!!! Finally someone that isn't a jerk and willing to offer help!!!
I wish I had FG to tip... I was TRYING to drag them to the left because thats were it sits....
Argggg all this time it was working.

thanks very much!

Are NEWER monitors more energy efficient?
Old simple 20" compared to this New 24" Viewsonic for efficiency

This post was edited by Randz66 on Oct 22 2017 04:07am

Not enough to make a difference unless you're upgrading from a CRT.

be nice to the op sir, or will report

he said thanks for posting in the subtitle you troglodyte
i was doing the polite thing

This post was edited by DCSS on Oct 22 2017 07:51am

you were spamming or upping you count all good here this thread can be closed