1995 Mazda miata, bearing went bad, so i began working on the car, exactly like this youtube video but i got stuck in the part where i have to pull the hub out, It some how got stuck and me and my buddy decided to hammer it down to pop it out and take in mind i Never done this before so i gave it a shot, long story short, the bolt got damaged so i had to grind it down to fit the under nut or what ever it's called so the bearing or i should say hub won't come off so that just says everything... It's stuck and i don't know how to pop that thing out. I'd have to replace the whole wheel hub assembly with the bracket and axle since it's all stuck. If i could find an alternative way i'd go that way first. ( he says it's welded in there) I Don't know.

If you been through this any tips/advice would be nice ! Thanks have a good one
have a good one

Get damage bolt out? Drill it out. Post pic of your fuck up.


This post was edited by charliemurphy on Dec 6 2013 02:03pm

I'm sure if i could drill it out i would've done it already.
I can't i don't have time at the moment and no garage i'd have to go rent one again. :|

Invest in some jack stands and tools

I do have tools but i have them one hour away from where i'm staying. I cannot drive that far, Nor go onto the freeway. There is this place that charges 15-25 bucks an hour and then lend you very tool you can think of and a garage(W lift) ! hehe
So i was thinking of going there instead.

http:// losangeles.craigslist.org/sgv/aos/ 4220263572. html

Yeah it seems legit. Pretty cool imo