i Know this is a newb question
this is just some rando picture and i think it made me figure it out, but help never hurts.
-in the red circle i have a heater hose comming out
-in the green i have my watter neck witch has a bung on it , i tried to install the sensor in that bung but it would touch the ''bottom'' before i could get the threads to hold onto the ''bung'' as if the sensor was to long.
-in the blue circle there is a bolt like the one in the picture witch i am guessing is just a plug, i tough it was a bolt holding down the intake, but silly me those go towards the heads not the block, im guessing this is the right location for my sensor?
ths is for some basic mechanical summit racing sensor