It's not a smudge. I addressed that earlier. It's on the inside of the lens. I took it apart and cleaned it with no result. I have to step on it and crack the screen or something to get a warranty replacement. My deductible is like $50. I don't care enough to do it as I only take pictures for shit like this once in a blue moon. It's a touch screen phone and everything on the screen rotates, there is no upside down. My hands were greasy so I was snapping and praying.


It does run extremely well. Almost too well. Woods racing is a blast.

clippy clippy





Reinstall the countershaft sprocket cover




Then the fun part of lining everything back up and sliding the axle in. It is a juggling act of keeping the spacers inside the hub and getting the caliper on the rotor, holding it with 1 hand, and sliding the axle in with the other.

A very light coating of anti seize compound with Molybdenum should be used on the outside shoulders of the axle. It looks cylindrical at first but it is not. The outer edges are slightly larger. These areas are what the bearings ride on.

This is the only one I took after the graphics that I can show. They are pre prints so my name is in the rest of them.

I just went out and pulled both fork legs off to send them out to Factory Connection to be revalved. Pictures incoming.