hey there you watch what you're saying lol

Millwrights have to understand how intricate pieces of equipment work. They have to work in ten thousandth of an inch increments. If you take a millwright and bash his brains out you have a pipefitter. Lay pipe, turn big wrenches, drool a little bit, hit stuff with a hammer. Ugg ugg.

lol i thought you were trying to say that were are stupid (im a millwright)

No no no. MW, sparkjerkers, and lucky shit's (instrument techs) keep our plant running. Pipefitters come and go. Generally they are big dumb ogres.


MW's are usually short and stocky. I think the average height is probably 5'6" out of the 40 or so we have on our site.



Edit: i picked up my rear bumper cover for the T/A Wednesday evening. It made it from socal to sc on a greyhound bus without any damage. I need to get a front end alignment done on it and get a quote for painting the car. I am going to the beach in september and i intend to drive it down there.

I might push for a cam swap between now and then but i doubt i'll have time.

This post was edited by FMX_89 on Aug 2 2014 09:53am

lol im the opposite of what you described im tall and lanky coming in at 6'4 and a whole wopping 170

i bench press more then you weigh lol

oh yeah well i dont even lift so come at me brah

me either lol. stil iso a ride in the vette

i was just up in Chicago for KOTS a while back but i think you were down working some where.

you should have pmd me lol. i was at ball state for 2 months ><