That sucks. Some of our welders at work shake (alcoholics) but as soon as they strike an arc their hands go perfectly steady. It's crazy.

We have a millwright in my area that trembles, I wouldn't even call it shaking. His nickname is rattlesnake. Somehow he manages to work on one of the most delicate pieces of equipment in our entire plant. He employs a lot of tricks, like dipping the head of all his allen wrenches and screwdrivers in a tub of grease to hold the screw in place.

I asked him if he drinks. He said no. I told him he should probably start, it might smooth things out.

honestly i dont tig much, theres just no reason for me to do it


90% of my shit is mig, and if its got good penetration and hold, i dont give a shit what it looks like

on customer stuff tho, i try to be better

I'm from Wisconsin so I'm not an Alcoholic. Just normal. which in Texas is considered an Alcoholic... However, i was born with it. Its a hereditary thing that runs in my family. My left hand is bad and my right hand is manageable. Fine for arc and mig, Horrible for Tig where I hold the gun with my left... I can however stick a tig stick to a piece of metal faster than anyone

Lol'd

QUOTE = Dept_Hammer,Dec 20 2014 08:01pm= ""

Did Stevie Wonder weld your pipes?

This post was edited by said_aouita on Feb 3 2015 02:46am

Had my friend weld a tiny crack
Idgaf as long as it doesn't leak

Thx for the examination

lol holy shit how did i miss that


heres the rule, if youre not going to be a welder, at least be a grinder

Lmao hey you guys aren't the only people giving me shit about that weld.
Trust me it's getting done right soon.

im running the same turbo hy35 9cm^2 housing it cant flow 500hp it only pushes about 50-54 lbs/min, you need an 8 blade hx35 14 or 16cm housings to flow above 60-65 lbs/min

This post was edited by Avenger987 on Feb 8 2015 07:13pm

i have made over 500horses on previous setups using this turbo. Lol.

e85, 30lbs, tuned

its doable without a doubt.