If its adjusted with screws maybe just a bit of plumbers tape, or low-strength thread locker, to keep vibrations from causing the screws to turn and the alignment to be knocked out of wack

So.. It's I'm just gunna buy nuts that fit onto the small thing spin them on and hope they keep the alignment in place.

why?


again, plumbers tape, or thread locker, these are products MADE to keep screws from unscrewing

i would go with a lower-strength thread locker, its sole purpose is to prevent screws from coming undone from vibration

Not sure if this has been covered or not but you should check the DOT website in your area to properly level your headlight as well, you could blind oncoming traffic.