Curious to where to place bungs in my piping for the injector(s)

Assuming WMI means water/methanol injection it needs to be sprayed 12-18" before the IAT sensor if possible. If not the IAT needs relocated to do it correctly. I'm running an Alkycontrol dual nozzle kit with 100% VP M1. Dual M15 nozzles so I'm spraying a lot. IAT goes from 120° in 100° ambient down to 70° by the end of a pull.

Right after the intercooler outlet imo.

I've never run a water/meth 50/50 or mix kit before. Never cared for them. So maybe I'm wrong?

Water was sprayed pre turbo inlet. Very low volume, Very high psi.
Meth was sprayed post intercooler outlet as far away from the intake manifold as possible. I've also always relocated the IAT because the 6.7's are funny and have the IAT much closer to the intercooler. That way your meth has more time to vaporize and cool before hitting the IAT and intake.

Please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please
please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please
please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please please
don't use windshield wiper fluid like an uneducated dumbass.

Interesting. As I was going to use a TB spacer on my Mazda but been advised it wouldn't be best as the TB Flap (w/e its called) could possibly hit the jet flow and impede atomisation.
As it goes - Intake | TB Spacer | TB | Intercooler piping.

I do recall someone saying about 12" away from the intake so I might just do that or do a little more research



99% methanol i can pick up 20L cheap here.

I had one in my 6.7, I took it out because I couldn't load 3 dirtbikes with the tank in my bed lol.

Good man, windshield wiper fluid doesn't do a fuckin thing, yet people do it.

That's not entirely true but ok

True enough to know that you're wasting your time doing it.

You think you know everything, then say stupid shit like this.

Do you inject windshield wiper fluid? Guess I wouldn't be too surprised....

Someone's salty as fuck.

Low freezing point plain washer fluid is water and methanol with blue dye. Water is actually better at detonation prevention than methanol but it slows the speed of the flame front in the cylinder. For your run of the mill boosted w/e a water/meth mix is cheaper and produces great results. 100% meth will make more power but does not have the anti-knock properties of water. Alkycontrol is actually the only system manufacturer that rates their systems for 100% meth as it is very hard on pumps. Even then 2-3 years is about all you get out of one.

I use VP M1 because I have complete control over my tune and I want maximum power production.