yep.

manual of the amp:


manual of the speakers:



so lets say im putting 2 wires from the amp to the front speakers. Now i got 4 wires coming from the speakers.
Do i just braze 2of the speaker cables with 1cable from the amp?

This post was edited by Flippi on Oct 20 2013 12:22pm

Really not sure why u have 4 Wires, check color codes form manual, see if two colors are + and two colors are -, then combine the two that are like and put into amp. Or use a connector

This post was edited by Bl00dy on Oct 20 2013 08:00pm

I would look at your component sets ohm load thyour component set will have 2wire input for the crossover&4 out. one set for tweets and one set for the driver. just treat the crossover as front speakers and wire from there.

yeah. so i combine 2 lets say plus wires from 1 site with 1 plus wire from the amp.
did i get that right?
uhm t
i just got small plugs there with this filter thing right behind the speaker. from there on i brazed them to the existing wires.
the speakers are functional with the radio atm but ofc i want em to run overthe amp. so yeah. right at the radio i got 4 wires coming from each side

This post was edited by Flippi on Oct 21 2013 01:45am