i wanna wire 2 speakrs (4ohm) to 1 channel (parallel)

where should i wire them togheter as close the speakers as possible or close the amp?

http://m.seimg.net/product/img/subwoofer_wiring/2_subs_SVC_4_ohm_mono.jpg

pretty much this.

cant i just run 1 long wire to the speakers than split it with a y-split?



This post was edited by Intenso8 on Jul 4 2013 07:13am

general rule in electrical wiring is the less wire exposed or jumpered the better. just run two separate wires for each of them. Not a big pain in the butt and a little bit more safe in terms the y can disconnect easier with something hooking on the wire.

not sure if read the first post or not...

just ran all like

works fine.

This post was edited by Intenso8 on Jul 4 2013 01:38pm

Cut the red wire