i got 2 subs both in there own box

12" Punch DVC Woofer.
Large, high temperature 2.5" voice coil.
Black anodized aluminum formers.
SantopreneTM Rubber surrounds.
Spruce Pulp Paper cones.
Large Powerful motors.
Hyper-extended pole piece.
2 x 4 Ohm Nominal Impedence.
Power Handling
400 Watts RMS/800 Watts Peak.
88.7 dB Sensitivity.
2.5 Inch Voice Coil Diameter.
6-7/32 Inch (15.8 cm) Mounting Depth.


i have 2 amps and there daisy chain and there kenwood amps both same 1800 watt but older model and other one is next years but one has output rca witch i pluged the amp into cuz i didnt want to run another cable to the deck any way to run these subs at 1 ohm cuz the amps can run at 1 ohm in there own box
heres video the amp on the right had RCA output witch i ran a RCA cable to other amp

read above can i do 1 ohm on each sub with the amps in daisy chain like that amps at 1 ohm rate at 900 watts

2 x 4 Ohm Nominal Impedence

If this is true and you have two amps then each amp should be at 2 ohms.
That amp puts out the SAME power at 1ohm and 2ohm, doesn't matter; it's regulated.

so how should i have them hooked it up

cant do this cuz each sub is in its own box

i guess can do 1 ohm but both subs need to be hooked together

the amps are http://www.crutchfield.com/S-ZEb6XUP4ljN/p_113KAC9103/Kenwood-KAC-9103D.html

amp 2 http://www.crutchfield.com/S-9tciaQZ3b0b/p_113KAC9104/Kenwood-KAC-9104D.html#overview-tab

those sites arent telling all the ohm rating