Quote (AbDuCt @ Dec 4 2011 12:38am)
have any recommendations of amps that i should install?
also since the person i got them from fixed the amp to the side of the box would it change the sound if i dont plug those holes by either remounting the newer amp there or plugging them in some how?
i'd have to double check the sub specs. i think they are 500rms a piece but i'm not 100% on it.
mounting the amp on the box is a last resort.
drywall puddy or bondo are the usual things people fill mdf in with but its pretty much opinion based.
how its wired will determine its ohm load. it also depends on the voice coil ohm loads.
i'm assuming they are wires to 2 ohms but i can't know for sure.
This post was edited by Subwoofer on Dec 3 2011 11:55pm