i got 3 amps, 1x1 and 2x4 channels, 1 of em got rca out

2 of them is allrdy wired up, how am i gonna split the rca's to get 4 more channels ?

what are the amps hooked up being used for
and what will the one being hooked up be used for?

4x 6x9"
2x 4"
2x 6.5"
2x 1" tweeters
2x 10" RF p2 subs

eq 2000 w 4 chan running 4x 6x9

eq 2000 w 1ohm digital mono running subs

the last one will be used for fronts

?

so you'd need to have one four channel amp power your front 4, and the second to power your back four then?

just use a RCA Splitter Female to 2x Male, so it would make it two for your left, two for your right, giving you the ability to make two left and two right RCAs so you can use a four channel amp

or are you wiring it differently?

well it is 6 in front but i donnu if it counts as 4 after its hooked up to an crossover, but else ye

i was thinking to do like ur saying, just wanted to be sure that i dont loose sound quality or something


from deck -> mono amp1
from deck -> 4ch amp2
from amp2 -> amp3 with 2x splitters

well, the one problem is that you have one three sets of rca cables, sub/front/rear

if you went from one amp to another, it wouldn't give you the actual rear sound (i believe)

huh ? i though the front/rear/sub controll was only for controlling sub vol. and using balance ? i dont use balance anyway

when an amp have rca out, do u think its bounded to both rca inputs or just 1 of em ? cause if it only uses 1 of em i can choose myself wich input i use anyway, but then again, 1 amp will be running both front+rear channels and next one will run 1 or both, depending on if the rca outputs is linked to 1 or both inputs, but does that rly matther anyway ?

This post was edited by lulzz on Sep 9 2011 12:55pm

one thing i'm still trying to figure it out, i've only seem them used for going to a mono or 2 channel amp if the headunit didn't have 3 sets of RCAs

well then it woulndt be a splitter but just a cable ?

i got 3 rca's front/rear/sub

if i was getting another 2channel it would just be a normal cable going from amp2 -> amp3, but i got 2 outputs and 4 inputs and need it splittet

Why do you need 3 amps?

You should be fine with a good 4 channel amp with 4 channels that have proper component speakers.



So you're running 500 watts per 6x9?

It must be shitty equipment.

This post was edited by Avoid on Sep 9 2011 11:46pm