how would i wire the head unit up? i plan on adding a aq4x90 to run a front componet set

are you wanting to keep using the infinity amp or do you want to bypass it?

If you want to use the infinity amp then the only thing you are going to change on the hook up is the factory plug in. Pin #12 is going to be the amp remote(orange/white wire) and you just need to pop the pin out on your radio harness, and move the remote wire so that when the plugs are connected, the remote fits into the #12 remote slot.

If you dont want to swap out the pin, just make a jumper wire and run the wire from the new harness remote plug in, and jump it into pin #12's slot.

This post was edited by nickerbocker57 on Jul 5 2011 02:58pm

dont really understand this


anywyaz i hooked everything up on my dining room table with a pc psu and it works perfectly

but im using an ipod instead of the headunit. illl try the headunit 2morrow.

Well the issue isnt going to be the actual headunit. Let me know if you still cant get this figured out, and ill see if i can draw you up a diagram to show you how to fix it.

well mainly im gonna try to figure out how to wire power to the head unit

Did you buy a wiring harness for the HU? getting power should be as simple as crimping the harness to the stereo wires, and plugging it into the car harness.

big hell yes for audio Q !!!