lmfao learn how to wire. 2 4ohm svc subs=2 ohm load. maybe try reading specs before running your mouth.

on top of the obvious wiring inability you clearly have no idea how subwoofers work and how bad it is for them to run at half power.

Audiopipe 1500.1D

You can get it for $150 with the same shitty warranty that has, and puts out more power.

touche' on the 2 ohm I overlooked that for some reason I thought they were dual 2's... and half powering a subwoofer does hurt it how would he be half powering those subs?

yeah except for it has been proven and clamp tested and the onyx is a lot cleaner and does rated while the audiopipe does not.

Weird, my AP1500 was getting ~1700rms @ 1 ohm.

that's a load of fucking crock... you're an idiot that must have been really fucking distorted and you called yourself an SQ setup

This post was edited by Hellish Orc on Feb 9 2012 10:04pm

sigh. you really need to learn the basics. if they are dual 2s when they either run at .5ohm or 2 ohm. so he would be trying to push 1400watts worth of subwoofer with 475 watts of amplifier.

this is going to kill the subs and the amps from overheating. if you knew the basics of how subs and amps work you would know how retarded you sound.

Says who? It all depends on the amps power supplier...

It can push out near 1800 on 14.4 volts.

ugh theres so much fucking shit going on I mean dual fucking 4's dude wtf... will you just get off my case. you're seriously looking retarded I thought they were dual 4's because the other Daytons are dual 4's and I got mixed up jesus

This post was edited by Hellish Orc on Feb 9 2012 10:08pm

No it can't you retard they're clamped doing about 1300-1400watts if that and that's maintaining 14.4v which I doubt you did. this board is so full of fail subwoofers like the only guy that knows anything lmao

This post was edited by Hellish Orc on Feb 9 2012 10:10pm