ya just hook them both into the 1 wire.

you can run bare wire if you want. just make sure its in there good cause if it comes out it can cause a lot of problems.

terminals are safer is all.

where do I buy more terminals? and do you use those plastic bitches on all of them?

stores like walmart/home depot.

plastic bitches?

if you end up wanting to try it out strip the wire enough where you can loop it completely around the screw before screwing it down. if you just stick it in on 1 side thats usually when it comes undone.

you slip it onaround the term and the wire

oh the sleeve things. you can just electrical tape them instead. all it does is cover that little bit of exposed wire.

you recommend terms though eh?

i prefer bare wire simply because it seems silly to me to use a small thin piece of metal when i have a lot of copper i can jam in there. direct wiring just seems better to me but i've never really compared the two in power handling.

if you can strip the wire enough to get it completely around the screw before tightening it should be perfectly fine and stay there until you want it out.

Mine seem really tight, and they seem to be wrapped around the screws
Pictures will probably be up at about 9 TN East, just have to work till 4:30