Okay So I am finishing my sleeve along with covering up a few places here and there.


In order to get the full design I am trying to put my complete current work on "paper" so that I can work from there and create the design


But I am having trouble getting a 2-d accurate schematic onto photoshop

Attempted:
re-drawing the full sleeve, but with imperfections would cause issues
Uploading 360 photos of the arm and tried meshing them together, unsucessful with quality and angle issues.





Does anyone have any suggestions on how this can be done?

E: nvm

This post was edited by Arcaeus on May 23 2014 08:43pm

got my hopes up

Bump

There's no sense in bumping a thread here, it'll stay on the first page for over a week

Ughhh time to try a new trick