Quote (valeribojinov @ Jul 13 2019 08:33pm)
Hey guys ,
I am planning to replace my current 5 channel AMP with a 4 channel AMP that i can borrow from a friend.
This is the AMP's specs :
Power at 4 Ohm: 4x100W
Power at 2 Ohm: 4x150W
Power at 4 ohm mode: 2x300W
Playing frequencies: 10 Hz - 50 KHz
Low Pass Filter (LPF): 40 Hz - 300 Hz
High Frequency Filter (HPF): 40 Hz - 300 Hz
Speaker Input: 2 ~ 16 ohms
So basically my question is :
Channel 1 : Rears
Channel 2 : Fronts
Can i then use Channel 3+4 on bridge for the Sub ? using the built-in low freq filter
The Sub is single coil 15` 4ohm
Will that run fine ?
Thank you in advance !
Yes you can, shouldn't be an issue.
You'll only see about 150w for that subwoofer though.
This post was edited by DatNiggaJesse on Aug 12 2019 05:57pm