K guys I have a Chevy 1ton c30 series they was no back breaks when I got it so I decided to work on em
Things new I have put on it so far are

2 rear wheel cylenders
New brake shoes
New lines going to rear drums
New break block
New break booster
New master. Cylender



I have blead the block the front breaks the back breaks and adjusted em and blead the master cylender as well and still can't get no peddle
Any ideas would be awesome seeing I have preauty much put a whole new break system I have ran out of ideas
I'm putting both breack calbers on new in the morning I hope they fix my problem but either way I should still have peddle

Lmk what u guys think I need some help bad

It may be electrical

what do u mean when you say you cant get no peddle ???

First off whats your problem here, whats happening all I'm reading is you changing stuff out but I have no idea what for?

This post was edited by Ford300Straight on Oct 13 2017 08:54pm

break fluid bro

loco cbaal-18////z can fix that

i cant get no break at all the peedle in the floor board keeps goin to the floor
i have checked every line makeing sure they aint no air in the lines and blead all calibers and cylender all day today
i went threw 4 bottles of break fluid bleeding em




when i got they truck i new they wasint any back breaks so u started from there first i replaced the rear wheel cylender on both sides and replaced the rear break shows
put it all back together and started bleeding not i had breaks on the fromt befor i even started
after i started bleeding the back breaks i noticed they was no fluid
so i changed the break block where all the lines connect to
i then replaced the break line leading to the back
finally i had fluid to the back breaks so i blead them untill all the air was out
remember i had i FRONT BREAKS befor i started after i got fluid back in all the lines i then had do breaks at all
so i replaced the master cylender and break booster i still have no peddle
remember i had great front breaks befor i started this project know i have non

4 bottles? seems like a leak from reservoir to the breaks / crap break lines maybe and or wasn't bled somewere correctly messin it up id assume master cylinder would be my first stop, u more or less did everything I can think of off hand , not connected to anything electrical that's not engaging them? edit nvm reread it sounds like a square body might be a few places on facebook or google which ppl talk about it might get what ur seeking or if all fails look on youtube

This post was edited by Death_tous_all on Oct 13 2017 11:50pm

need new brake lines

Check the ground around and undearneath your truck. if you see any fluid on the ground then there's a good chance you are leaking brake fluid, but it does sound like it might be an electrical issue to me

This post was edited by Zpot on Oct 14 2017 01:30pm