Quote (Unholy-Knight @ 26 Sep 2017 14:16)
there is a metal box with quite a few wires coming out of it in the top left, which of those would you need?
I noticed that after I took the pis and cleared it out as best as I could.
good, did you remove the old thermal paste residue, then re-apply a fresh one?
also make sure you evenly tightened the screws with a "X" pattern, slightly screw each opposite corner little by little til all of them are snug.
As for the power supply, just anything to indicate the wattage/sticker info etc.
This post was edited by Secksii on Sep 26 2017 06:59pm