Quote (Motorbreath @ Apr 15 2017 06:52pm)
sweet thanks, now i just need to measure and figure out where to put in my truck lol, i dont think it will fit behind my seat since its 4" wide
24x14x4"
Looks like I can only fit an amp thats 13" wide underneath my front passenger seat and it's a powered seat which wouldn't work that well. I only have 2" of depth between the rear seat and back of truck.
I might have to consider running a 1 amp system which I can mount inside the sub box as long as it's smaller than 11" x 15". This would power the front components and sub, rears would be hooked up to HU.
also takes away from displacement though and can effect tuning if its ported, I don't think I like the idea of extra heat in a sealed box tbh and for the record mdf wood sucks if you get that box wet it will be done for
I like sundown but those speakers need more depth, 4.5" mounting depth so that wont work in the box, and you cant make a ring for them because you would hit the floor on excursion (recommended 1.5" clearance)
ts amp should work just fine ik lots of guys running that stuff
so that being said u may have to make feet for you back seat to get the height I know some of those prefab companies may work with you
And for the record theres nothing I hate more then a component speaker, get some eminence alphas!
I have a phoenix gold sd series 800.4 that ive been very happy with it so far, works good for the workin truck"
everythings just about gone class d so highs amps aren't as outrageous as they once were when u would look at 1000$ a/b amps lol
where do you live, it might be a good idea for you to head to a few car audio forums and look for a builder, u will get more box and not spend a whole lot more then u already are I figure
This post was edited by TanKiE on Apr 16 2017 07:10am