got all the outside of the bed done today going to try and get the insides done tomorrow.

oooo that's an ugly wrinkle on the body line drivers side.

Fix that one before you paint. It's going to stick out like a sore thumb. Also, it looks like your primer is tiger stripped pretty bad.

Might want to take some more time on this.

not being a dick, just trying to save you some headache.

real paint is going to be a good bit off still just trying to get the truck all one color.
but what your seeing in the primer was just wet spots

we will see how much more i can get done i wont be able to get more primer till friday

This post was edited by night_throne on Feb 22 2017 12:15am

got the inside of the bed done today!
also im putting up a picture of the primer im using in case any one wanted to know. its 3.68$ at my local walmart and lays on great.

Ouch that wrinkle is gonna show bad. Not sure how to fix that ? Pound it out ? Bondo and sand ?

all of the above. ive got a friend whos going to help me with the body work.

sadly i have had no time to work on the truck but hey i found photos i forgot to post up!

that was the inside of my old thermostat housing.

and last but not least the wonders of needle bearings breaking in a ujoint

finally got some money again and was able to do some work on the truck.
now mind you the following photos are of my hei distributor and it ran and drove just fine. all this was found because im swapping out the intake for the weiand one i have sitting around.



and yes the icm is cracked