Quote (FMX_89 @ Dec 27 2016 05:15pm)

It would need a corvette tail housing and I'm not sure what else. I'd have to look it up as I doubt it's ever been done.

Quote (FMX_89 @ Dec 27 2016 04:13pm)

Not in the slightest. You can wish it to be true all you want but I'm perfectly content with my car. In a couple years I'll sell it and build/buy something else. Maybe a TT C6 grandsport or C7.

Quote (jimmyhoud @ Dec 27 2016 07:16pm)

I would imagine the gearing inside is all different too. It'll be to short for what you want.

With that said, you could use the case? LOL

What are the new c7z's running? Are they still in a 56 or did they jump to a 6060 now?

Edit -- nvm lol, had a brain fart and realized they jumped to that fancy new 7speed

Quote (CuttingEdge @ Dec 27 2016 07:17pm)

Simple minds are fixated by simple things.

Quote (FMX_89 @ Dec 27 2016 05:50pm)

Yeah they are 7 speed. 08-13 vettes used 4 different versions of the 6060. I looked up the gearing in yours and it's crazy short for me but I could probably work something out with RPM, Tick, or RKT56 to use it as a core. PM me with what you had in mind and we'll see what we can work out.



So that is why you are fixated on this simple thread about a driveline vibration?

Quote (FMX_89 @ Dec 28 2016 12:50am)

Yeah they are 7 speed. 08-13 vettes used 4 different versions of the 6060. I looked up the gearing in yours and it's crazy short for me but I could probably work something out with RPM, Tick, or RKT56 to use it as a core. PM me with what you had in mind and we'll see what we can work out.



So that is why you are fixated on this simple thread about a driveline vibration?

Quote (jimmyhoud @ Dec 27 2016 06:56pm)

I'll crack it open this weekend and send you pictures and we can work something out if that's the route you want to go.

Quote (jimmyhoud @ Dec 27 2016 07:56pm)

I'll crack it open this weekend and send you pictures and we can work something out if that's the route you want to go.

Quote (FMX_89 @ Dec 27 2016 06:48pm)

If it's still in good usable condition i'll take it as is. I should be able to swap it with a shop that rebuilds them for a corvette core of equal value. I'll send a couple emails out to the shops I listed.

Quote (Subwoofer @ Dec 27 2016 06:20pm)

you just wanted to tear it apart without the wifey complaining about the mess didn't you.

Quote (jimmyhoud @ Dec 27 2016 09:30pm)

It should be fine. Last setup that trans ran was the stroker pre-blower so only 600ish crank hp.

It's been sitting at the shop on a pallet ever since (15-16 months ago) so I haven't even looked at it. I'll have the guys pull it down for me this week so I can bring it home.



Gotta have something to do... She put me on spending hold after seeing the bill for the refresh on the 572 :(