So this will be a second installment of my original work-log for jsp. The full detailed work-log will still be my thread on OCN. http://www.overclock.net/t/1392251/project-dayz/0_20

Now that my hand has healed up and I have some money saved up I can finish this build. Most of the pictures will be cellphone pictures as I haven't really bothered to use my camera. Enjoy.




It looked like crap in it's present state so I decided to start tearing it apart. I was going to finish this monster I created.

Have fun and I can't wait to see the ocs u gonna have goin for benches arnt you goin to sell it tho? Atleast I though that was the original plan

So after gutting most of everything, removing the motherboard, redoing my tubing, installing a second HDD, removed the ROM drive, etc.,

I got to here:

Doing a test run on some acrylic I had. I am going to paint one side black so it makes it glossy. This in turn will allow my UV cathodes to reflect off the acrylic and give more volume to the case.




I added the acrylic backplating I've been wanting as a test fit. It too will be painted on the far side black. This way I can drill some holes into the acrylic to make for a very useful wire management peg-board. It will also block the view of the wires. Sexy idea...





This post was edited by NinjaSushi2 on May 20 2014 09:38pm

Old overclock high.




I still plan on selling it but originally I was going to do 3 way CF. The board supports 3 way CF, 4 way SLI. (I don't get that..) So I have that 1000W Seasonic Platinum which I hope will be enough for my rig and some OC headroom. If not I still plan on selling it regardless. haha Then take the money I get and roll it into a new project. Hopefully I will have enough to buy all the parts outright and not have things take forever.


So my GPU should be here soon but I still need to buy the block and find someone to laser mill a small piece out for my. The biohazard on the block or possible make it something else.


Edit: I'll update tomorrow with pictures of what I am doing plus the tools I am using. Jigsaw, drill press, etc. I need a milling bit or a router. Dang I also need to buy a rotary tool and a flex shaft.

This post was edited by NinjaSushi2 on May 20 2014 09:53pm

I'm back from a derpy moment. I'm thinking about putting acrylic behind the motherboard along the back frame. What say you? I can't decide if it is too much work or if it is too darn cool.

If I do, so much for the paint job
Haha

This post was edited by NinjaSushi2 on May 31 2014 12:22pm

Dremel is a shit brand and a band saw is what I require. Though the jig saw did an average job. I only use multi rotary tools for incisions and detail.

I'v cut myself open pretty badly with a bandsaw in the past, lmao def not going anywhere near those ^^

i have a permanent scar on my chest near my right ribs because of a stupid swing set made of metal when i was 6 years old.
i still remember how it looks inside of me and how red my flesh was.
i even remember one time when i burned my belly to the point my skin was actually cooked with boiling water; every time i touched it i re-felt the same sensation of the boiling water going on my skin and i can eat a soup just fine and boil some water and it was when i was 8 years old during the summer.

/e and i just remember i was bitten on my right arm by a dog when i was 12 years old and i don't even care when i see a dog near me....

This post was edited by dolarsignzeroxeighty on Jun 1 2014 10:41pm

So does that mean your computer is a zombie computer?