i just got myself a cap

i heard that its an good idea to charge it before connection it directly to my battery, i got a small resistor for that

i heard u can use a light bulb too and that way see when its fully charged, but i donnu how this works (something about 5w bulbs only ?)

some say that i put + to resistor to + on cap, others say something about resistor on both +- or something like that, been tryint go search but its confusing

allso i got 2 amps, so it will go battery -> fuse -> cap -> distribution block -> amp -> amp ?

This post was edited by lulzz on Mar 11 2012 01:21pm

u have 3 wire kits and 3 fuses ?

no i dont yet, i will go buy cable and what else i need when i figure out the wiring

where should i put those 3 fuses ? i will need a new distribution block anyway so would it work with that with fuses in it ? the manual dont say anything about extra fuses

Caps kill your alternator

Iv never had an alternator issue.

Well its just more logical to go with a power cell

i will do big 3 and get a better battery, i just got this cap for free and i dont believe its doing more harm than good

A battery would be more likely to fry an alternator than a cap lol.

im only running around 1000 wrms so my stock alt and bat is doing okey atm, with big 3 + cap i think it will run fine

when im getting new subs i will change the battery and mb alt if needed

doesnt anyone know about charging/wiring and these 3 fuses this dudes talk about ? :/ i need to know what to buy so i can get this done as soon as posible

haha yeah. my buddy was running 3 amps off 2 batterys. killed his alt and 2 brand new batterys lol